A1220LUA-T【PDF 10/16 页】IC HALL EFFECT LATCH 3V 3-SIP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录59

6页 7页 8页 9页 [10页]11页 12页 13页 14页

Chopper Stabilized Precision Hall Effect Latches

A1220, A1221,

A1222, and A1223

Allegro MicroSystems, LLC

115 Northeast Cutoff

Worcester, Massachusetts 01615-0036 U.S.A.

1.508.853.5000; www.allegromicro.com

BYP

A122x

VOUT

GND

0.1 糉

VCC

Output

Operation

The output of these devices switches low (turns on) when a mag-

netic field perpendicular to the Hall element exceeds the operate

point threshold, B

(see panel A of figure 1). After turn-on, the

output voltage is V

OUT(SAT)

. The output transistor is capable of

sinking current up to the short circuit current limit, I

, which is

a minimum of 30 mA. When the magnetic field is reduced below

the release point, B

, the device output goes high (turns off).

The difference in the magnetic operate and release points is the

hysteresis, B

HYS ,

of the device. This built-in hysteresis allows

clean switching of the output even in the presence of external

mechanical vibration and electrical noise.

Removal of the magnetic field will leave the device output

latched on if the last crossed switchpoint is B

, or latched off if

the last crossed switch point is B

Powering-on the device in the hysteresis range (less than B

and

higher than B

) will give an indeterminate output state. The cor-

rect state is attained after the first excursion beyond B

or B

Applications

It is strongly recommended that an external bypass capacitor be

connected (in close proximity to the Hall element) between the

supply and ground of the device to reduce both external noise

and noise generated by the chopper stabilization technique. As is

shown in panel B of figure 1, a 0.1 糉 capacitor is typical.

Extensive applications information for Hall effect devices is

available in:

" Hall-Effect IC Applications Guide, Application Note 27701

" Guidelines for Designing Subassemblies Using Hall-Effect

Devices, Application Note 27703.1

" Soldering Methods for Allegros Products SMT and Through-

Hole, Application Note 26009

All are provided in Allegro Electronic Data Book, AMS-702, and

the Allegro Web site, www.allegromicro.com.

Figure 1. Switching behavior of latches. In panel A, on the horizontal axis, the B+ direction indicates increasing south polarity magnetic field strength,

and the B direction indicates decreasing south polarity field strength (including the case of increasing north polarity). This behavior can be exhibited

when using a circuit such as that shown in panel B.

(A)

(B)

Functional Description

HYS

OUT(SAT)

B+

V+

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式